Sharkrack KVM-8 User Manual download pdf (Page 20)

KVM-8 Installer/User Guide

On-Screen Display Operations

System Cont rol and Ma intenanc e

The following commands are used for system control and maintenance. Enter the

command sequences to perform the actions described in the table below.

Key Sequen ce

Act ion

<CM>Kn<Enter> Sets the keyboard scan set where n is a scan set number 1-3.

<CM>MR<Enter> If you hot-plug your mouse cable, you may experience a loss of

mouse signal. Use this command to restore the signal if you are

using a PC with a standard PS/2 mouse driver.

<CM>MW<Enter> If you hot-plug your mouse cable, you may experience a loss of

mouse signal. Use this command to restore the signal if you are using

a PC with a Microsoft IntelliMouse or other wheel mouse driver.

<CM>AV<Enter> Displays the current rmware version of your KVM Switch.

<CM>SG<Enter> Enables the scan Go command (by address only).

<CM>SH<Enter> Enables the scan Halt command.

<CM>M+<Enter> Enables mouse suspension of scanning.

<CM>M-<Enter> Disables mouse suspension of scanning.

<CM>H1<Enter> Changes the hot-key sequence to the default: (NumLock, -).

<CM>H2<Enter> Changes the hot-key sequence to the 1st alternate: (NumLock, *).

<CM>H3<Enter> Changes the hot-key sequence to the 2nd alternate: (CTRL, ~).

<CM>OSD0<Enter> Disables the OSD Sequence.

<CM>OSD1<Enter> Changes the OSD sequence to the default: (CTRL, CTRL).

<CM>OSD2<Enter> Changes the OSD sequence to the 1st alternate: (Alt, Alt).

<CM>OSD3<Enter> Changes the OSD sequence to the 2nd alternate: (Shift, Shift).

<CM>ZM<Enter> Use this command to resynchronize the mouse after a device or

computer hot-plug. Repeat, if necessary, until synchronization is re-

established. N ote : Using this command while the mouse is operating

correctly will cause the mouse to lose sync.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Sharkrack KVM-8 User Manual Page 20