Sharkrack T3-R19-H User Manual download pdf (Page 3)

T3 Rack Mount Kit Installation Instructions

SHP900096-000 04/13/05 Rev 2 Page 3 of 5

Installation Instructions

Step Detail

1. Measure the distance from the front rack rail to

the rear rack rail.

Distance = _________

2. Assemble the left front mounting bracket, rear

mounting bracket, and back plate in the order as

shown. Set the front and rear mounting brackets

at the distance measured in step 1.

3. Secure the left front mounting bracket and rear

mounting bracket to the back plate using four

8-32 x 3/8-inch flat head screws.

Note: Do not tighten the back plate screws at this

point.

4. Repeat steps 1 through 3 to assemble the right

front mounting bracket, rear mounting bracket,

and back plate.

5. Install the left front mounting bracket, rear

mounting bracket, and back plate (assembled in

step 2) in the left side of the rack enclosure.

Note: Make sure that the mounting flange on the

front mounting bracket is on the bottom.

• Attach the front mounting bracket to the front

left rack rail using three 10-32 x 1/2-inch pan

head screws. Use the first, third, and fourth

screw holes on the front mounting bracket.

• Attach the rear mounting bracket to the rear

left rack rail using three 10-32 x 1/2-inch pan

head screws.

6. Once the assembly is secure in the rack

enclosure, tighten the back plate screws (the

screws installed in step 3).

7. Repeat steps 5 and 6 to install the right front

mounting bracket, rear mounting bracket, and

back plate in the right side of the rack enclosure.

1 2 3 4 5

No comments

Sharkrack T3-R19-H User Manual Page 3